Cooling is a GO

I got the new fittings and hoses hooked up then flushed the water chiller and the induction heater. No leaks, cooling is a go!

Cooling - connected and flushed

Cooling - New metal base for cart

Before putting it back on the cart I replaced the top plastic liner with 16 gauge sheet metal that I cleaned and lightly wiped down with oil. I think I’ll go back and add a lip around 3 sides with the box break to catch any falling sparks and molten beads of metal that try to escape.

Back on the cart!

Cooling setup on cart

And here it is with cooling set up on the new cart.

Cooling setup on cart

Now to move on to power. I am making a quick disconnect near the breaker box. I will need to draw and 3D print a small enclosure for the 3/8″ dual splicers. More on that progress here.

Leave a Reply

Your email address will not be published. Required fields are marked *